Help. Which wires on ECU to connect S-AFC with a 9

[96integrals]

I have a 96 LS and I just got the Apexi' SAFC, but there are no instructions for the LS engine. Only B18C. Is it the same as on the GS-R??

Can someoen tell me which wires on the ECU to connect to? Cause there are so many wires connecting into the ECU box and I tried looking at this honda book but it doesn't say.

There are only 7 Wires (1 Power, 2 ground, 1 rpm signal, 1 throttle signal, 1 for air flow output, and 1 for air flow input)

Thanks.

[INTEGRA LSSC]

it uses the same diagram as the gsr. i believe in your case you need to use diagram h6-a if you have manual tranny and h3-c if you have an auto. make sure your ecu matches the diagram h6-a. if not see if it matches h2-a. i'm not sure if you got an obd1 or obd2 ecu.

------------------
95 Integra LS, 6psi JRSC, JR BTC, DC 4-2-1 header,DC catback,AEM cai,Mugen Thermostat, Testpipe, Apexi SAFC,&more coming soon.

[This message has been edited by INTEGRA LSSC (edited April 11, 2001).]

[INTEGRA LSSC]

by the way, it's page 23 in the manual that says "vehicle specific wiring diagrams"

------------------
95 Integra LS, 6psi JRSC, JR BTC, DC 4-2-1 header,DC catback,AEM cai,Mugen Thermostat, Testpipe, Apexi SAFC,&more coming soon.

[INTEGRA LSSC]

also remember when putting the ground wires on, the brown wire has to be tapped closer to the ecu than the black wire.
you'll have to cut the pressure signal wire. the yellow wire will connect the cut wire leading to the ecu and the white wire will connect to the other half of the cut wire.

if you do not feel comfortable doing this install i'd recommend having a professional do it.

------------------
95 Integra LS, 6psi JRSC, JR BTC, DC 4-2-1 header,DC catback,AEM cai,Mugen Thermostat, Testpipe, Apexi SAFC,&more coming soon.